OMK-V Series

Resim

The OMK-V Pump is a vertical axis, radially split, ring section design multistage centrifugal pump of non-self priming type.
Impellers are between bearings, single entry, closed type and dynamically balanced.
OMK-V pumps have bearings that support radial and axial thrust forces.
On the bottom there is a water-lubricated sliding gear.
Thrust is balanced by means of back wear rings. Any remaining unbalanced thrust is supported by ball bearings.
Pumps with exchangeable wear rings are available upon request.
The pump series consists of 5 sizes that they are 32, 40, 50, 65 and 80 types.
Pump and motor are fitted on a common base plate and connected to each other via flexible coupling.
Normally, discharge part is at motor side on top and suction part is at dead end side at the bottom. Rotation of pump is clockwise when viewed from driver.

In pumping of pure or relatively clean liquids in;